Ross DRA-8604, Руководство пользователя

Страница: 33 / 44

DRA-8604 User Manual (Iss. 02) DashBoard Menus • 4–3
Hardware Tab
Table 4.2 outlines the read-only information displayed in the Hardware tab.
Channel #
Output
Unlocked (muted) Reclocker is enabled and unlocked
Reclocker bypassed
Input signal is present but the reclocker is
bypassed (the Enable Reclocker check
box is not selected in the Setup tab)
No signal (muted)
Input signal is not present and the output
is automatically muted
Input Cable Length
(m)
x (1694A) / y (1855A)
Indicates the approximate cable length
used for the input signal where:
• x represents the Belden 1694A length
• y represents the Belden 1855A length
N/A
A valid input source was not detected on
the input BNC
Backup Input
(HD-BNC 2)
Input No signal
• A valid signal is not present on BNC 2
or
• The Channel Options menu is set to
Single Channel in the Setup tab
a. If the fields are labeled as Channel A-1 and Channel A-2, the Channel Options menu is set to Single Channel.
b. The Enable Reclocker check box is selected for the specified channel.
c. The Enable Reclocker check box is not selected for the specified channel.
Table 4.2 Hardware Tab Items
Tab Title Item Parameters Description
Hardware
HW Status
OK (Green)
The rear module installed with the card is
supported and the card is operating
correctly
Wrong Board Type (Red)
Board type on flash does not match the
board type resistor
Incomp Rear Module (Red)
An unsupported rear module is installed
with the card
Voltage (mV) # Supply Voltage
Current (mA) # Current consumption of card
CPU Headroom # Processing power available
RAM Available # On-board processing memory available
Uptime (h) #
Displays the number of hours since the
last reboot of the card
Configuration Bank # Storage count
Table 4.1 Signal Tab Items
Tab Title Item Parameters Description