Ross ASI-310, Руководство пользователя

Страница: 20 / 34

20 • Physical Installation ASI-310 User Guide (v5.0)
15. If desired, connect wires from the GPI/O jacks on the rear panel to your monitoring equipment, as described in
the section “ Connections Overview ” on page 16.
Installing the ASI-310
This section outlines how to install a rear module and card in a openGear frame. Refer to the section “ Connections
Overview ” on page 16 for cabling details.
Rear Modules
When installing the ASI-310:
• DFR-8310 series frames — The MDL-R10 Full Rear Module is required. The ASI-310 is not compatible with
the DFR-8310-BNC frames.
• DFR-8321 series frame and OG3-FR series frames — The MDL-R20 Full Rear Module is required.
Installing a Rear Module
If the Rear Module is installed, proceed to the section “ Installing the ASI-310 in an openGear Frame Slot ” on
page 21.
To install a rear module in your openGear frame
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the ASI-310 installation.
3. Install the bottom of the Rear Module in the Module Seating Slot at the base of the frame’s back plane.
4. Align the top hole of the Rear Module with the screw on the top-edge of the frame back plane.
5. Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back plane of the frame. Do
not over tighten.
6. Ensure proper frame cooling and ventilation by having all rear frame slots covered with Rear Modules or Blank
Plates.
Screw Hole
Module Seating Slots