Ross ADA-8501, Руководство пользователя

Страница: 14 / 24

JP4 Fault Report
Figure 2. Jumper Locations
Fault Report Jumper Setup
Select SMPTE 269M Fault Reporting, EN ABLED or DIS ABLED, via JP4 . The default is EN .
See Chapter 3, “ SMPTE 269M Fault Reporting ” for details on fault reporting.
Board Installation
Use the following steps to install the ADA-8501 in a RossGear 8000 series digital distribution frame:
1. Refer to the User Manual of the RossGear 8000 series frame, to ensure that the
frame is properly installed according to instructions. If this module is to be installed
in any compatible frame other than a Ross Video product, refer to the frame
manufacturer’s manual for specific instructions.
2. Please note that heat and power distribution requirements within a frame may dictate
specific slot placement of cards. Cards with many heat-producing components
should be arranged to avoid areas of excess heat build-up, particularly in frames
using convectional cooling.
3. After selecting the desired frame installation slot, hold the ADA-8501 card by the
edges and carefully align the card edges with the slots in the frame. Then fully insert
the card into the frame until the rear connection plug is properly seated.
BNC Labels
Affix the supplied BNC label, as per the included instructions, to the BNC area on the rear of the rack
frame.
2-2
•
Installation and Setup ADA-8501 User Manual (Iss. 03)