Ross ADA-7801, Руководство пользователя

Страница: 13 / 20

Cable Connections
This section provides instructions for connecting cables to the ADA-7801 when mounted in RossGear
frames. See the following frame rear panel diagram for cable input and output designations:
On the rear of the Ross frame there are removable connectors for the mono input and eight mono
outputs. See Figure 3 below and the manual for the frame in which you have installed the ADA-7801
for further details on cable connections.
Figure 3. ADA-7801/A Cabling Designations for RossGear 7814C and 7812C Series Frames
Each connector has sockets for the positive, negative, and grounded wires of a balanced analog audio
cable. Wire the external cables to the removable terminal block connectors as outlined in the figures
and procedure below.
Figure 4. Connector Wiring for ADA-7801 Inputs and Outputs
1. Insert an audio wire into the designated polarity slot on the connector.
2. Use a tweaker screwdriver to tighten the corresponding screw on the underside of
the connector.
3. Repeat steps 1 and 2 for each wire on each connector.
4. Secure the cable to the connector with a tie wrap.
5. Once the cables have been wired to the connectors, install the connectors to the
sockets on the RossGear frame so that the slotted tongue fits in the grooves on the
frame’s mating connector.
ADA-7801 User Manual (Iss. 08) Installation and Setup
•
2-3