Ross ACO-4400A, Руководство пользователя

Страница: 64 / 112

5–10 • Front Panel Menu System ACO-4400A User Manual (Iss. 03)
System Setup Menus
Figure 5.6 provides an example of the System Setup Menu.
Figure 5.6 System Setup Menu Example
The System Setup menu provides a gateway to the less frequently used options in the
ACO-4400A.
These options include:
• Extended information in the form of reports, Extended configuration options,
• Access to factory settings that the user should never have to access or adjust, but may
contain useful information to communicate to the factory during a service event.
Temperature Reports
The Temperature Report appears below (general form).
Figure 5.7 Temperature Reports Menu Example
The Temperature Report provides information on the temperature sensors within the
ACO-4400A. A typical example might look like: “
+3v3 Regulator 42 45 41
“
Depending on the exact configuration and options in the ACO-4400A, one or more of the sensors
might not be installed. In this case, the description in the relevant line appears as seen in
Figure
5.7 . These menu lines report the power cycle counts and “in service” times for both of the PSUs
installed in the N+1 Dual Redundant PSU ACO-4400A.
Because the temperature report includes not only the current temperatures and both the minimum
and maximum temperatures detected by the installed temperature sensors, but also power supply
“in-service” data, this information might be useful if you are experiencing reliability problems in
an extreme environment.
Note
— Reports contain information only; there are no editable fields in these menus.
— Network —> Menu Enter
— Calibration
—>
Menu Enter
— Configuration —> Menu Enter
— System Report —> Menu Enter
— Event Report —> Menu Enter
— Temp Report Menu Enter —>
L PSU on for hhhhh.ddd hours
+3v3 Regulatory
L PSU turned on nnnnn times
N+1 Interface
R PSU on for
hhhhh.ddd hours
R PSU turned on nnnnn times
42 45 41