Ross ACO-4400A, Руководство пользователя

Страница: 51 / 112

ACO-4400A User Manual (Iss. 03) Operating Basics • 4–7
To upload software files to the ACO-4400A
1.
On your PC, launch the “
RossSystemUpdate_v#.#.#.#.exe
” program.
The Ross System Update dialog opens.
Ross System Update Dialog
2. Set the IP Address and IP Mask fields to the values for the ACO-4400A you want to
upgrade. Note that all octets must be entered as 3-digits. For example, 255.0.0.0 should
be entered as 255.000.000.000.
3. Click Get Device Mode .
The status field, located above the Ross logo, updates to display: “
The device is in
Application mode.
”.
4. If the ACO-4400A is “not found”:
a) Check again that all connections have been made.
b) Verify that the IP Address and IP Mask values were entered correctly in step 2.
c) Power off the ACO-4400A.
d) Repeat step 1. to step 3.
5. If the ACO-4400A still cannot be found, contact Ross Video for further assistance.
6. To load a file:
a) Click Open File to display the Open File dialog.
b) Select the relevant “*.ata” file.
c) Click
OK to load the file into the Ross System Update Tool and close the Open File
dialog.
d) Click Send to Device .
e) If this is the first file to be uploaded, you will be asked to confirm the upload.
7. Monitor the upload:
a) The software will put the ACO-4400A into Bootload mode.
b) The Ross System Update Tool erases the old ACO-4400A file.
c) The Ross System Update Tool uploads the new file to the ACO-4400A. Upload of a
file takes approximately 1 minute.
d) The status messages field in the Ross System Update dialog confirms that the
upload was completed successfully.
e) If the upload was not successful, click Send to Device and monitor the process.
8. Once all files have been uploaded successfully, power-cycle the ACO-4400A.
9. Verify the software version of the ACO-4400A in DashBoard as follows:
a) Launch the DashBoard client software on your PC.
b) Locate the ACO-4400A in the Basic Tree View in DashBoard.