
PAGE 8
Rositek Technologies
www.rositek.com
© 2021 Rositek
All rights reserved
Email: [email protected]
USER GUIDE AND TROUBLESHOOTING
Loading
Materials
1. Prepare materials you wish to make.
2. Take out the mold ram, and separate the housing and base.
3. Put a piece of parchment paper through the U-shape grooves on both ends
of the base.
4. To align the U-shaped grooves at both ends of the housing with the base
and push it inward until it is stuck so that the base will not fall off.
5. To load materials into the mold, press it down. Flatten it out on the top after
full to make sure the material is distributed evenly.
6. Put the second parchment paper on the top.
7. Set up the ram of mold.
OPERATING INSTRUCTIONS
Tips:
The recommended size of parchment paper is width 126mm and length larger than 80mm to
prevent it from sticking.
Pressing
with MPP2
Manual Presser
1. After loading material inside of the pollen mold.
2. Push the mold in-between the base of press and the threaded rod of the
press and make sure it installs completely.
3. Rotate the lever handles clockwise, and you can select the corresponding
hole according to different directions to increase the pressure, until no more
pressure can be applied.
4. Rotate the lever handles counterclockwise to get the mold out of the
machine.
Tips:
Capable of Being Heated - The
mold made of 6061 aluminum always
transfers and retains heat to melt the
materials, so you can pre-heat the mold
or materials before loading complete or
heat up the mold with hot water/another
method after loading the materials.