PAGE 10
Rositek Technologies
www.rositek.com
© 2021 Rositek
All rights reserved
Email: [email protected]
USER GUIDE AND TROUBLESHOOTING
Step for
Pressing Material
1. Insert the included power cord into the power cord socket and then plug the
other end into an electrical outlet.
2. Turn the knob clockwise until it is firmly closed to seal the release valve.
3. Flip the ON / OFF switch to turn the press on. The PID temp controller and
the power switch both become lit.
4. Press the PID control panels to set the desired temperature (About how to
set the temperature, please refer to
Page 11
)
.
5. Wait until the platens heat up to the desired temperature.
6. Place the prepared materials in the center of the bottom platen.
7. Pump the jack handle to lift the bottom platen up.Continue pumping until the
desired pressure is reached.
8. Turn the valve knob counterclockwise to release the press and lower the
bottom platen.
9. Remove the pressed material using heat resistant gloves or tools.
10.Remove the jack handle from the jack handle socket.
11. Turn the machine off by flipping ON / OFF switch when done pressing.
12.Unplug and then disconnect the power cord from the press.
13. Wait until the press cools down completely to clean and store it.
OPERATING INSTRUCTIONS (continued)
CLEANING
PRESS PLATES
1. Make sure the press plates are completely cooled down before cleaning.
2. Apply a small amount of alcohol to a clean cloth and wipe down the plates
until clean. Use rubbing alcohol that contains at least 80% by volume of
isopropyl alcohol.
3. Wipe plates with a dry clean cloth.
4. Repeat these steps for cleaning all associated tools.