ROSIERES RDVE342, Инструкция пользователя

Страница: 10 / 36

Error code Description Possible error cause Error clearing
E2 Overheating of the induction coils / Cooling down necessary
ER03 &
Permanent use of keys; Water or cooking utensils on the Cleaning of the
permanent tone
Control unit cuts off after 10 sec glass above the control unit operational surface
E5 Error on filter board Controller flash defect; check sum not correct Exchange filter board
5V short circuit with power unit
12V on power unit too low
temperature sensor at cooling body defect
mains synchronous impulse incorrect
Unknow error,
cannot be cleary identified
E9 Exchange temperature sensor
ER12 Control switches off after 10 sec Short-circuit in the 5V or earthed control relay Exchange control unit
Control switches off after
60sec at the latest
Short-circuit or disconnected Remove the cause
pan sensor or power supply (customer service)
ER20 Flash-failure µC- faulty Exchange control unit
Control unit cuts off after controlling Standard algorithm reaches limit when Allow cavity to cool down.
due to overheating to overheated. Ambient temperature of Check heat sealing-off
avoid damage to the electronics electronics still to high of control unit.
Key evaluation defective;
after 3.5 – 7.5 sec
Secondary voltage of the power
supply unit too high (primary>300V).
Control switches off after 1s and a
permanent acoustic signal is heard
Relay voltage too high in switched
-off condition (nominal: 0 Volt)
ER31 Configuration data incorrect Configuration data incorrect Configuration necessary
ER33 Clean
NTC value is not within it’s
specification (value < 200mV or
>4.9V; control unit cuts off)
Faulty feedback of shift register
or relay activation
ER39 turn-off and call Customer Service
Secondary operational voltage is
identified under tension;
Operational voltage is
the adjusted value
Communication error between None or faulty Ensure that connection cable
TC and induction communication is plugged on correctly
Secondary voltage of the power
unit to high (primary > 300V). Control unit is wrongly connected. Connect to correct
Control unit cuts off after 1sec
mains voltage
releasing a permanent tone.
“H” Wait until the control card returns
Flashes to the normal temperature
FA Error on key "ON-OFF" emitter Security key error
FC Error on key "ON-OFF" receiver Security key error
FE Ntc short Touch error
Ft Ntc open Touch error
Fc Over temp T>96°C Touch error T<96°C
Fr Error on relay Touch relay failure
FH Eeprom check sum Eeprom checksum error
FJ Error on Adc Security key error turn-off and call
F0 Error on Sw Software error Customer Service
FL Error on ambient light Keyboard error
FU Error divisor Security key error
turn-off and call Customer Service
Hot pan on the control card; faulty radiant hotplate seal
ER47
U400
Wrong programming options (fuses, lockbits)
ER40 Primary PTC too hot min.5 s too low, according to
ER37
Return of sliding register signals to select,
turn-off and call Customer Service
signals to the segment
segment or relay triggering incorrect
Water on the glass above the control card
ER36 Short-circuit or discontinuation at NTC Exchange control unit
ER25 Control wrong connected Connect to correct mains voltage
ER26 Short circuit in the relay voltage control Replace the control
Short-circuit or discontinuation at NTC
Exchange control unit control unit cuts off
in the range of the key evaluation
ER16 Control switches off
ER21
ER22
Coil temperature sensor defective
ER13 Component part defect Exchange control unit
E6 Error on power unit Exchange power unit
E7 Sub LIN error between filter and power unit turn-off and call Customer Service
Disconnect control unit from
the power system
too different from ER42
The voltage is exceeding from the valid range
or there is too much variance
turn-off and call Customer Service