Installation Guide VW Series
Rosen Entertainment Systems
Copyright 2008 all rights reserved
Installation Guide
DP-VW0714 Rev A
Page 3
5 - Remove the Factory Radio
You will need to remove the Factory Radio and prepare the Rosen Multi-Media unit for installation. The following steps
will help guide you through this process.
Note
: Be sure to inspect all brackets and clips to ensure they were not damaged during the removal process. If any
brackets or clips were damaged, replace them prior to installation of the Rosen unit.
Step 1: Remove the OEM Radio
Trim
Step 2: Remove Radio Mounting
Screws
Step 3: Remove Radio Mounting
Screws
Step 4: Remove OEM Radio from
Dash. Unplug Factory
Harness
6 – Locate the GPS Antenna, Optional XM Antenna and iPod Interface
You will need to mount the GPS and Optional XM Antennas on the exterior of the vehicle. And mount the iPod Interface
Connector in the vehicle. The following steps will help guide you through this process.
Note
: Please route the GPS harness away from other power harnesses in the vehicle. This will help to ensure
optimum performance of the GPS system.
Note
: Please locate the iPod interface module in an area which can be serviced in the future. The iPod cable is
intended to be a serviceable item, which plugs into the iPod/XM Interface Module.
Step 1: Mount the GPS and XM
antenna in a location on
the exterior of the Vehicle
Step 2: Connect the Optional XM
Tuner as shown below.
Mount the tuner inside the
vehicle
Step 3: Mount the iPod/XM
Interface module where it
can be serviced in the
future
Step 4: Locate the iPod interface
connector for use by the
end-consumer
It is the installer’s responsibility to ensure that the safety equipment in the vehicle is NOT
adversely affected by installation of this system. Ensure that the routing of the harnesses does
NOT obstruct airbags, SRS or other safety devices.
Use Caution. See the OEM Service Manual for additional information on the removal process
