Installation Guide Subaru Legacy
Rosen Entertainment Systems
Copyright 2010 All Rights Reserved
Installation Guide
DP-SB1024 Rev B
Page 4
OEM Radio Antenna Tip:
For easier access to antenna connector, push connector
through trim panel near carpet as show at right
Remove OEM Mounting Brackets
Remove left and right mounting bracket from OEM radio
and re-install on Rosen unit with ROSEN SUPPLIED
SCREWS
DO NOT use OEM screws
LOCATING REMOTE COMPONENTS
You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the
vehicle. And mount the iPod Interface Connector in the vehicle. The following steps will help guide
you through this process.
STEP
3
Use Caution around SRS Components
I
t is the
installer’s responsibility
to ensure that the safety
equipment in the vehicle is
NOT
adversely affected by
installation of this system. Ensure that the routing of the
harnesses do NOT obstruct airbags, SRS or other safety
devices.
Mount the GPS and Sat Radio antenna in a
location on the exterior of the Vehicle
Route the GPS harness away from other power harnesses in the
vehicle.
This will help to ensure optimum performance of the GPS
system.
CAUTION
