Installation Guide Mazda CX-7
Rosen Entertainment Systems
Copyright 2009 all rights reserved
Installation Guide
DP-MZ0744 Rev B
Page 4
7 – Connect and Install the Rosen Unit
You will need to make the Electrical Connections and install the Rosen Unit. The following steps will help guide you
through this process.
Note
: Connect BRAKE WIRE (blue w/ white) to Emergency brake switch wire (ground when E-brake is
engaged). This insures video is disabled while vehicle is in motion.
Note
: Use caution when locating the wire harnesses to be sure they will not be damaged when the Rosen unit is
installed.
Note
: For vehicles with Dual Diversity Antenna, connect the White Antenna lead only, and protect the second
antenna lead from damage. For improved Radio performance, use an aftermarket dual diversity antenna adaptor.
Step 1: Remove transport
screws
Step 2: Connect the GPS
Antenna, Steering Wheel
Control and Power
Connections
Step 3: Connect iPod, Optional
Sat Radio, Camera and
Backing Sensors
Step 4: Prepare the Vehicle side
connection harnesses
8 – Re-Install Interior Trim Components
You will need to re-install the interior trim components. The following steps will help guide you through this process.
Note
: When Installing the Interior Trim Components, use caution to prevent damage to the components. If you are
unsure about the removal process, consult the OEM Service Manual for additional instructions.
Step 1: Reinstall and reassemble
the hazard switch
Step 2: Install Rosen unit into
dash using factory screws
Step 3: Reinstall the radio bezel
and vents starting from the
top.
Step 4: Installation complete
Use Caution. See the OEM Service Manual for additional information on the installation process
Insure that the video disable connection is connected as intended and working as designed!!!
Be sure to fully engage all connectors and prevent them from causing vibrating noises
