Installation Guide Mazda CX-7
Rosen Entertainment Systems
Copyright 2009 all rights reserved
Installation Guide
DP-MZ0744 Rev B
Page 3
5 - Remove the Factory Radio
You will need to remove the Factory Radio and prepare the Rosen Multi-Media unit for installation. The following steps
will help guide you through this process.
Note
: Be sure to inspect all brackets and clips to ensure they were not damaged during the removal process. If any
brackets or clips were damaged, replace them prior to installation of the Rosen unit.
Step 1: Now with all 4 screws
removed
Step 2: Disassemble switch by
pulling away from front of
radio
Step 3: Remove factory alignment
pin and reinstall into
Rosen system
Step 4: Remove the factory
(white) clips and reinstall
on the Rosen system
6 – Locate the GPS Antenna, Optional Satellite Radio Antenna and iPod Interface
You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the vehicle. And mount the iPod
Interface Connector in the vehicle. The following steps will help guide you through this process.
Note
: Please route the GPS harness away from other power harnesses in the vehicle. This will help to ensure
optimum performance of the GPS system.
Note
: Please locate the iPod interface module in an area which can be serviced in the future. The iPod cable is
intended to be a serviceable item, which plugs into the iPod/Sat Radio Interface Module.
Step 1: Mount the GPS and Sat
Radio antenna in a location
on the exterior of the
Vehicle
Step 2: Connect the Optional Sat
Radio Tuner as shown
below. Mount the tuner
inside the vehicle
Step 3: Mount the iPod/Sat Radio
Interface module where it
can be serviced in the
future
Step 4: Locate the iPod interface
connector for use by the
end-consumer
It is the installer’s responsibility to ensure that the safety equipment in the vehicle is NOT
adversely affected by installation of this system. Ensure that the routing of the harnesses does
NOT obstruct airbags, SRS or other safety devices.
Use Caution. See the OEM Service Manual for additional information on the removal process
