Rose electronics Vista L SERIES, Инструкция по установке и эксплуатации

Страница: 19 / 36

OPERATIONS
Vista KVM-Series Installation and Operations Manual
13
Operating instructions
The Vista switch is very easy to operate. Computer selection and set-up
functions are entered from the keyboard. You can also select computers
manually from the Vista’s front panel by using buttons 1-2 or buttons 1-4
depending on your model.
Keyboard command
Following is a description of the Vista keyboard command functions.
The <Ctrl> input key sequence is a press and release of the left control
key. Within 2 seconds of pressing and releasing the left <Ctrl> key, enter
the next command.
Command Key Sequence Description
Reset
command <Ctrl> R Resets and enables mouse
and keyboard, enables PS/2
mouse on currently selected
port.
Reset mouse
command <Ctrl> O Sends reset mouse command
to currently selected CPU. Will
recover stuck NT mouse.
Send null byte <Ctrl> N Used to re-synchronize PS/2
mouse.
Identify ROM
version <Ctrl> I Identifies ROM version, CPU
must be at a command prompt,
word processor, or text editor to
receive value.
Keep <Ctrl> K Saves current scan state and
custom settings.
Scan time
interval <Ctrl> Txx <Enter>
(xx = 1 – 16 sec.) Sets the pause time for each
port when scanning.
Mode
command <Ctrl> M x <Enter>
Where:
x = 1 for mode 1
x = 2 for mode 2
x = 3 for mode 3
x = 7 for mode 7
x = 8 for mode 8
x = 9 for mode 9 First select the CPU port to
configure, and then enter the
mode command.
Mode 1, 2, 3 for keyboard:
Mode 7, 8, 9 for mouse