Rose electronics Orion XTender OR2-SRDFSUD1D, Инструкция по установке и эксплуатации

Страница: 55 / 79

Orion Extender Installation and Operation Manual 52
Transmitter AND Receiver Settings
The following settings must be written to the configuration files of
both
Transmitter and Receiver.
Setting Function
Local switching (only with HDMI extenders and local control by an USB-HID Receiver upgrade module)
BLANKSCR Activate dark switching between local and remote console by keyboard or mouse event
PRIVATEMODE
Activate switching of video and control between local and remote console by keyboard
commands
USB 2.0 Embedded
ENAUSB11
Activate USB 1.1 mode for USB 2.0 embedded upgrade modules (only with USB 2.0
embedded upgrade module)
DISUSBAUD Disable USB audio codec
ENAMICAMP Activate microphone amplifier
Table 18. Configuration File Settings Required by Both Transmitter and Receiver
Shared Operation of Redundant Interconnects on Transmitters
On Transmitters that have redundant interconnects, situations may arise where multiple Receivers
simultaneously attempt to control the Transmitter by using the keyboard and/or mouse on the Receiver.
The Configuration File , described on page 50 , specifies a RELEASETIME setting to resolve this situation. This
setting specifies the length of time in seconds of keyboard and mouse inactivity after which another Receiver’s
keyboard and mouse can take control of the Transmitter.
Open the “ Config.txt ” file, which can be found on the “ Extender ” flash drive, as described in the beginning of
this section. Activate the release time function by adding the RELEASETIME=n setting in the second line of the
file, where n is the time in seconds before the Receiver gives up control. It can take a value from 0 to 9. For
example, a setting of RELEASETIME=5 sets the release time to 5 seconds.
If the RELEASETIME setting is not found in the file, it is set to 2 seconds by default. Use the
RELEASETIME=X setting to deactivate this function.
Once the needed changes have been made, save the “ Config.txt ” file and reboot the unit so that they can take
effect.
Note:
When the Orion Xtender is used along with a KVM matrix switch, the RELEASETIME function is
deactivated on the extenders, and is handled instead by the switch.
Shared Operation of Redundant Interconnects on Receivers
Conversely, when working with Receivers that have redundant interconnects, keyboard commands can be
used to manually switch between two active connections. This is helpful to perform a 2:1 switching operation if
there are different Transmitters connected to each interconnect.
The following keyboard commands are available to switch between the Transmitters.
Keyboard Command Function
<'Hot Key'>, <k>, <1>, <Enter> Switch to Transmitter on Receiver
Interconnect Link 1
<'Hot Key'>, <k>, <2>, <Enter> Switch to Transmitter on Receiver
Interconnect Link 1
Table 19. Keyboard Commands for Shared Operation of Redundant Interconnects on Receivers