Rose electronics MultiStation ML-2U, Инструкция по установке и эксплуатации

Страница: 20 / 36

OPERATION
14
MULTISTATION INSTALLATION AND OPERATIONS MANUAL
Dip Switch Settings
The front panel dip switch enables or disables commands from each KVM
station. To enable commands from a KVM station put the corresponding dip
switch in the up position. To disable commands, put the switch in the down
position. The dip switch on the right controls KVM #1, the next switch controls
KVM #2, and so on. The below table shows the dip switch configuration and
each settings function.
DIP SWITCH CONFIGURATION / DESCRIPTION
Up – enable commands Down – disable commands
Switch location Model ML-2U Model MK-4U Model MLK-2U
8 KVM 1 KVM 1 Local unit
7 KVM 2 KVM 2 Remote unit
6 No effect KVM 3 No effect
5 No effect KVM 4 No effect
1 - 4 No effect No effect No effect
Example shown enables KVM 1 and KVM 3 and disables KVM 2 and KVM 4
Table 7. Dip Switch Settings
1 2 3 4 5 6 7 8
IMPORTANT OPERATION NOTES:
1. To issue any keyboard command, first press and release the
right control key (Ctrl) then within 2 seconds issue the
command or it is aborted.
2. Use only the numeric keys above the keyboard for entering
numeric commands. Numeric keypad entries are not
recognized. All numeric commands must use the [Enter] key to
complete the command.
3. Keyboard commands are not case sensitive and are shown
capitalized for clarity only. DO NOT USE THE SHIFT KEY