- 7 -
FUNCTIONS AND OPERATION
MONITOR
1. POWER LED
When the red LED is on, it indicates power on, monitor in standby mode, waiting
for trigger signal.
When a trigger is selected, the image captured by the selected camera will
appear on the monitor.
2. An on-screen scale will appear when the trigger (typically rear-view) for camera 3 is
energized.
3. Pressing the power switch will change the monitor status from standby to
steady-on. Steady-on mode status indicated by green LED light.
4. In steady-on mode, driver may activate the scale by pressing the SEL button.
Pressing SEL again will remove the scale.
5. CONTROL BUTTON
These control buttons are used to adjust the values within selected options
6. SEL.
SELECT CONTROL BUTTON
Use the button in order to select the required option in the menus.
* NOTE: Prior ro accessing menu options, place monitor into
steady-on (Green Light) mode
7. ‘MENU’ Button
Each press of “Menu“ button will bring up one of the following screens.
See next page for details.
• PICTURE
• OPTION
• SYSTEM
The menu list will disappear if no selection is chosen within 15 seconds.
8. CA.SEL
Camera selector button
Enables selection of CA1, CA2 and CA3.
The OSD (On Screen Display) indicates which camera is currently operating.
9. REMOTE-CONTROL SENSOR
The monitor can be operated via remote control. If using remote control,
ensure that the IR on the remote control is facing the monitor.
pq
