Safe-T-Scope
®
7" MIRROR MONITOR KIT
STSK4730
MONITOR INSTALLATION
The STSM244 7" Windshield Mirror Monitor is designed to attach to the windshield button of the
vehicle. An additional windshield button is included with the STSK4730 kit. The
standard mount STSDF1003 is compatible with many common vehicle models. Please contact
your Rosco dealer for alternative mounting options.
•
Once the monitor is mounted, if necessary, drill a 1" diameter hole near the monitor through
which to pass the monitor cable and 13-pin connector. Clear any obstacles before drilling holes.
•
Connect the black wire from the power harness to chassis ground. Connect the red wire to an ig-
nition switched accessory (ex. radio) power source and ensure that the power source can provide
operating current above 2 Amps.
•
Connect the blue trigger wire to the vehicle's reverse signal circuit. DO NOT connect trigger to
any constant power source. Connect the STSH343 camera extension cable to the connector
labeled "C3 REAR" on the power harness.
•
Connect the STSH130 standard-to-mini adaptor to the STSH343 camera extension cable.
•
Connect the STSC130 camera to the STSH130 standard-to-mini adaptor.
•
Connect the monitor's 13-pin connector to the power harness' 13-pin connector. Make sure the
arrows on both connectors are aligned and pointing towards each other.
•
All connections should be completely hidden from the vehicle operators. The harness should be
tied/clamped to a rigid structure or rigid existing vehicle harness.
•
Adhere to a 2 inch bend radius for all cables to prevent damage.
FUEL TANKERS & OTHER SPECIALTY VEHICLES:
•
All electrical equipment fitted to petroleum vehicles must be connected via battery master switch.
The electrical equipment must be isolated from the battery while the vehicles are loading and
unloading. For other specialty vehicles, please check applicable codes and regulations prior to
installation.
•
Always consult your dealer when adding any electrical or electronic equipment to a vehicle fitted
with a CAN-bus multiplex system.
WIRING INSTRUCTIONS
4 5
Fig. A
TORQUE 4 SCREWS TO 7 IN-LBS
