www.rosco.com
p. 7
The projected aperture appears out of round or cut off.
2.
The DMX Iris is not properly seated in the luminaire. Remove Iris unit
•
and reinsert making sure that the unit is seated all the way down in
the light.
The manual control knob won’t turn.
3.
Make sure the DMX Iris is unplugged and no power is getting to the
•
unit. The manual knob will not turn when power is present.
Irregular or failed DMX Control
4.
Check that the DMX Address is set properly.
•
Check that proper DMX signal is present (is the display flashing
•
LOST
/
512
?)
If the DMX Iris is at the end of the DMX chain, connect a proper DMX
•
terminator to the OUT port of the DMX Iris.
Specifications
Power
Input 100 -240 v 50-60 hz, < 500 mA power draw
Cord
18AWG 3C SJT, IEC/NEMA Connector
Motor
24v 1.8° Stepper Type
Aperature
10mm - 75mm
Mechanism 24 leaf iris, bonded stainless steel
Temp
450° C at iris leaves
Made in Taiwan
Copyright 2010 Rosco Laboratories Inc.
