Rosco CubeConnect, Руководство пользователя

Страница: 25 / 37

Multiple Wireless Transceivers
25
When using multiple wireless Transceivers, the Slave Transceivers must be
paired to the Transceivers they're listening for. For example, if there are two
Transceivers present, the single Slave must be paired to the Master.
If there are three Transceivers present, the 1st Slave must be paired to the
Master, but the 2nd Slave must be paired to the 1st Slave.
Use the LEARN BUTTON to pair this Slave unit to the Transceiver it's listening
for with the following procedure:
1) Put the Slave (the Transceiver that you are going to "learn") into Wireless
IN/DMX Out mode.
2) Put the unit the Slave will be listening to into DONGLE PAIR mode.
3)
Make sure these are the only two Transceivers powered up.
4)
Push and hold the
LEARN BUTTON
on this unit for 12 seconds then release
and verify
LEARN INDICATOR
flashes 15-20 times (this forces the unit to clear
any "Learned" units from its memory).
5) Push and release the LEARN BUTTON again, then verify LEARN INDICATOR
flashes 3-4 times (this teaches the unit to only listen to the "other"
Transceiver).
6)
Put this Slave unit back into
DMX IN/WIRELESS OUT
mode to use it as a
multiple wireless slave Transceiver.