80
3
Award BIOS Setup Utility
3.1.5.8 Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your
system.
Delay 4 Sec.
Regardless of whether the Power Management
function is enabled or disabled, if the power but-
ton is pushed and released in less than 4 sec, the
system enters the Suspend mode. The purpose of
this function is to prevent the system from
powering off in case you accidentally “hit” or
pushed the power button. Push and release again
in less than 4 sec to restore. Pushing the power
button for more than 4 seconds will power off
the system.
Instant-Off
Pressing and then releasing the power button at
once will immediately power off your system.
3.1.5.9 Resume on PCI Event
Enabled
This field should be set to Enabled only if your PCI
card such as LAN card or modem card uses the PCI
PME (Power Management Event) signal to remotely
wake up the system.
Access to the LAN card or PCI
card will cause the system to wake up.
Refer to the
card’s documentation for more information.
Disabled
The system will not wake up despite access to the
PCI card.
3.1.5.10 Resume On LAN
If you are using a LAN card that supports the remote wake up
function, set this field to Enabled. The will allow the network to
remotely wake up a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can wake up the sys-
tem only through an IRQ or DMA interrupt. Refer to “Wake-On-
LAN Connector” in chapter 2 for more information.
