21-30265 REV A
3
4 INSTALLATION/
GENERAL
FUNCTIONALITY
Your new positioner is intended for years of service free use. The positioner is not
intended to be serviced or troubleshot for major issues in the field, a troubleshooting
guide for minor issues is provided in Section 8. Please contact your sales representative
for any issues with your new positioner.
To install your new positioner, use the bolt pattern provided on each output shaft or an
available ROS mounting bracket. Note that your connector configuration will have a
specific wiring configuration. The wiring for your positioner will be designated on the
supplied test certification, but the standard wiring configuration can be found in Section
7.
Figure 1: Output Shaft Bolt Pattern
