Roros Metall Vero, Инструкция по эксплуатации

Страница: 9 / 64

EN
9
9
USE
Control panel
Button Function Led
A Motor off. The Leds indicating the Speed of the motor turn off.
Enables / Disables Keyboard Lock mode if pressed
and held for 5 seconds.
All the Leds light up in cycle and run a start-up sequence.
B Activates speed one. The Leds indicating Speed one and Motor Off turn on.
C Activates speed two. The Leds indicating Speed two and Motor Off turn on.
D Activates speed three. The Leds indicating Speed three and Motor Off turn on.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
on.
To turn it off, press and hold the button again for 5
seconds.
Button A LED flashes twice.
Button A LED flashes once.
E Activates speed four. The Leds indicating Speed four and Motor Off turn on.
Press and hold for 5 sec. to activate Intensive
speed. This speed is timed to run for 10 minutes. At
the end of this time the system will return to the
speed set previously.
It is disabled by pressing the Button or turning the
Motor off.
The Led flashes once a second and button A Led lights up.
F Starts the 24H function, in which the motor starts at
a speed that allows suction of 100 m3/h for 10
minutes per hour. This mode cannot be activated if
Intensive or Delay modes are active.
To deactivate it, press the same button or button A .
The Leds indicating 24H speed and Motor Off turn on.
24H Led Flashing:
Indicates the need to wash the metal grease filters. The alarm is
triggered after the Hood has been in operation for 100 working
hours.
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for
approximately 5 seconds. These indications are
only visible when the motor is turned off.
The button A Led flashes three times
G Activates Delay mode, causing automatic
shutdown of the Motor and the Lighting system
with a 20’ delay.
It is disabled by pressing the button or turning the
motor off.
The Delay and Motor Off button Leds turn on.
Delay Led Flashing:
Indicates the need to change the activated charcoal filters, and
also to wash the metal grease filters. The alarm is triggered after
the Hood has been in operation for 200 working hours.
Pressing and holding the button for 5 seconds
enables the remote control.
Pressing and holding the button for 5 seconds
disables the remote control
Button A Led flashes twice.
Button A Led flashes once.
H Press briefly to turn the lighting system on and off
at maximum intensity.
The Led on the button lights up.
Press and hold the button for 2 seconds to turn the
Courtesy Lights On (if provided).
The Led on the button lights up.