26
TF 200.02.0026_eng
7.
Cleaning
During use, the product may get dirty. It is important that the washbasin and the lifting unit are cleaned in
accordance with these instructions.
Ropox StandardLine may be wiped with a wrung cloth with lukewarm water and a mild detergent. Do not use
corrosive/grinding fluids or scouring sponges and brushes.
Cleaning of washbasin
Wash the surfaces daily with water and wipe with a dry cloth. Do not use cleaning agents containing hard
abrasives
– such as steel wool, scouring powder, or sulfuric acid.
If the water has a high calcium content, calcareous deposits will often occur in the washbasin. These
deposits should be removed at least once a week by using a detergent containing citric acid, acetic acid, or
phosphoric acid. Leave the detergent to work for 5-10 minutes depending on the thickness of the deposits
and clean thoroughly with a soft sponge.
Disinfection of the washbasin may be done with household disinfectants.
8.
Troubleshooting
Notification!
Do not use cleaning agents containing abrasive e.g. scouring powder, steel wool, scouring
sponge.
This product is not designed to be sterilized, autoclaving and sterilization beyond normal
cleaning may change the product safety and function.
Problem
Solution
The washbasin does not move
up or down when pressing the
hand control
Check if:
➢
230 V is connected, and if the power is on.
➢
The engine is connected to the control box.
➢
The control is connected to the control box.
➢
The actuator is overloaded. (NOTE: For every 2 minutes of
activity, it needs 18 minutes of rest).
Hand control is defect
Check if:
➢
The washbasin is height adjustable by means of another
control.
When pressing the UP and
DOWN buttons, only “click”
sounds come out of the control
box
– no movement
➢
The plug may not be mounted correctly.
➢
Demount all cables from the control box, and mount again.
➢
A ”Reset” might be needed. See the instructions below.
The frame seems loose or
unstable
➢
Tighten all screws of the frame, cf. mounting instructions.
The washbasin cannot be
height adjusted or the
adjustment feels very difficult
➢
Check that there are no jammed objects preventing the height
adjustment.
It takes too long for the water
to leave the washbasin
➢
Check the siphon for clogging and clean it, if required.
➢
Check that the flexible hose has not been mounted so high on
the wall that it acts as an additional siphon.
➢
Check that the connection hoses are not kinked or twisted on
the hose. Adjust the hoses so that they are not kinked/twisted.
