Page | 16
TF 200.01.0020_ENG
Alternative
35 mm
(1.4in)
5.1.2
Installation of control with lock function
•
For ease of installation, before mounting a front fascia, pre-drill two holes in the tabletop
for the control.
•
Mount the control with lock function on the bottom side of the table, by means of two Ø
4.5mm countersink screws. It is recommended that the tilted part of the control is outside
the fascia, as shown below.
•
Connect the control to the control box.
•
If a fascia is needed, cut out a small indent in the front fascia that measures 20x67mm
(0.8x2.6in). The control can be mounted further in on the tabletop than recommended. If
it is, it is recommended to increase the height of the indent to 35mm (1.4in). Mount the
fascia.
Notice!
DO NOT attempt to mount the control with lock function on a hard tabletop such as glass
or stone, with screws.
20 mm
(0.8in)
67 mm
(2.6in)
Worktop
Front fascia
Sideview
