Application
Page 4
RES-403
1.5
Line filter
The use of an original ROPEX line filter is mandatory in
order to comply with the standards and provisions
mentioned in section 1.6 "Standards / CE marking" on
page 4. This device must be installed and connected
according to the instructions contained in section
"Power supply" as well as the separate documentation
enclosed with the line filter.
1.6
Standards / CE marking
The controller described here complies with the
following standards, provisions and directives:
Compliance with these standards and provisions is only
guaranteed if original accessories and / or peripheral
components approved by ROPEX are used. If not, then
the equipment is operated on the user's own
responsibility.
The CE marking on the controller confirms that the
device itself complies with the above-mentioned
standards.
It does not imply, however, that the overall system also
fulfils these standards.
It is the responsibility of the machine manufacturer and
of the user to verify the completely installed, wired and
operationally ready system in the machine with regard
to its conformity with the safety provisions and the EMC
directive (see also section "Power supply"). If periph-
eral components (e.g. the transformer or the line filter)
from other manufacturers are used, no functional guar-
antee can be provided by ROPEX.
1.7
Maintenance
The controller requires no special maintenance.
Regular inspection and / or tightening of the terminals –
including the terminals for the winding connections on
the impulse transformer – is recommended. Dust depo-
sits on the controller can be removed with dry com-
pressed air.
1.8
Disposal
This device is subject to Directive 2012/
19/EU concerning the reduction of the
increasing amount of waste electrical
and electronic equipment and the dis-
posal of uch waste in an environmentally
sound way.
It must not be disposed of as residual
wase! To guarantee proper disposal and / or the
recover of reusable material, please take the device to
adesignated municipal collectin point and observe local
regulations.
Careless, uncontrolled disposal can cause damage to
thenvironment and human health. By ensuring that
yourproduct is disposed of or recycled in a responsible
way, you can help protect the environment and human
halth.
2
Application
This RESISTRON temperature controller is an integral
part of the "Series 400", the outstanding feature of
which is its microprocessor technology. All RESI-
STRON temperature controllers are used to control the
temperature of heating elements (heatsealing bands,
beaded bands, cutting wires, heatsealing blades,
solder elements etc.), as required in a variety of heat-
sealing processes.
The controller is most commonly used for impulse-
heatsealing PE films in:
• Vertical and horizontal f/f/s machines
DIN EN 61010-1:2001
(2014/35/EU)
Safety requirements for electrical
equipment for measurement,
control and laboratory use
(low-voltage directive):
pollution degree 2,
protection class I,
measurement category I
(for U
R
and I
R
terminals)
DIN EN 60204-1
(2006/42/EG)
Electrical equipment of
machines (machinery directive)
EN 55011:2009+A1:2010
EN 61000-3-2:2006-04+
A1:2009+A2:2009
EN 61000-3-3:2008
EN 61000-6-4:2007+
A1:2011
(2014/30/EU)
EMC genery emissions:
Group 1, Class A
EN 61000-6-2:2005
(2014/30/EU)
EMC generic immunity:
Class A (ESD, RFI, burst, surge)
Exception:
Line voltage interruption acc. to
EN 61000-4-11 is not fulfilled
(This leads to a designated error
message of the controller)
