PD-3 / PD-5
Installing the PD-3/-5
(assembly of P-3/-5 and KD)
Proceed as follows to assemble/install the
potentiometer:
1. Make a cutout in the front panel
(
section „Dimensions“ on page 2).
2. Insert the KD fine control knob
into the front panel
cutout and screw it tight with the nut
.
For assembly of the nut
a hock spanner
(DIN 1810 contour A, diameter 32mm) shall be
used.
3. Screw the lock washer
onto the P-3/-5
potentiometer with the two hexagon nuts
.
4. Turn the potentiometer shaft counterclockwise as
far as the minimum resistance setting (0ohms).
Note: This is NOT necessarily the same as the shaft
end stop!
5. Turn the dial of the KD fine control knob
until the
display indicates "000". Loosen the locating screw
on the underside of the knob.
6. Insert the shaft of the P-3/-5 potentiometer into the
KD knob from behind. The lock washer
must
snap into the lugs on the KD knob. Then tighten the
locating screw
again.
The shaft of the P-3/-5 potentiometer and the
dial of the KD fine control knob must remain
absolutely stationary until the installation is
complete. If they are moved, the display on the
knob will deviate from the value set with the
potentiometer.
How to order
KD knob
Front panel
cutout
Potentiometer
P-3 / P-5
!
Precision potentiometer with digital fine control knob
PD-3 (resistance 2kohms, display 0…300): Art. No. 881103
PD-5 (resistance 2kohms, display 0…500): Art. No. 881105
Precision potentiometer (as spare part)
P-3 (resistance 2kohms, 3 turns):
Art. No. 881003
P-5 (resistance 2kohms, 5 turns):
Art. No. 881005
Fine control knob with digital display (as spare part)
KD:
Art. No. 881113
