Assemble the brackets to the
frame as shown, using 8x 25mm
hex head bolts & washers.
The height of the frame and
distance from the wall can be
adjusted manually with the bolts
found on the top fixing bracket
and the legs of the frame. Loosen-
ing the bolts will allow the frame to
be adjusted accordingly. Use a
spirit level to ensure the frame is
level. Re-tighten the bolts to
secure the frame into its new
position.
Using the dimensional drawing
above as a guide, mark and drill
holes in the appropriate places
using a 10mm masonry drill bit. If
the frame has been adjusted,
mark off the new hole positions
accordingly. Use a piece of
masking tape to prevent the drill
from wandering.
Using the wall fixings provided,
secure the frame to the wall.
Ensure that the fixings supplied
are suitable for the installation in
hand. If in doubt consult an
expert.
1. Using a craft knife, cut the protective casing so that it is flush with the wall.
2. Screw the plastic fixing arms supplied with the flush plate into the protective casing. A quarter turn should
secure the arms in place.
3. Fix the flush plate mounting bracket to the fixing arms using a screwdriver as shown.
4. Take out the hoses so that they can be accessed for fitting the flush controls.
5. Connect the hoses, making sure that the blue hose is connected to the half flush connector as shown.
6. Locate the right side of the flush plate onto the mounting bracket and push to the left to locate.
installation of flush plate
installation of wall hung frame
10
460
350
780
75~95
240
336
1.
4.
5.
6.
2.
3.
tip
Take care using power tools – The
use of a residual current device
(RCD) is recommended.
Beware of hidden cables or
pipes when drilling.
3
6
