ROOTS RootsSweep B70, Руководство пользователя, Страница: 13 / 21

13
RootsSweep B70
MACHINE OPERATION
Changing the side aprons
Ÿ
Unscrew the screw connections in the side aprons.
Ÿ
Change the sealing strips and adjust the side
aprons. There must be approx. 1 - 2 mm clearance
to the floor.
Ÿ
Screw the screw connections back in the side
aprons.
Changing the rear aprons
Ÿ
Remove the dirt hopper.
Ÿ
Unscrew the screw connections in the rear aprons.
Ÿ
Change the sealing strip and adjust the rear apron :
The clearance of the rear apron from the ground
must be 1 - 2 mm.
Ÿ
Screw the screw connections back in the rear
aprons.
Dirt Hopper
Before starting any maintenance and repair work,
set the key switch to Position 0 to prevent starting
the machine inadvertently!
4
1. Seal for dirt hopper
2. Handle for dirt hopper
3. Dirt hopper
4. Handlebar
Removing the dirt hopper
Ÿ
Switch the machine off looking in drive direction, at
the same time, pivot the handlebar forwards. The
hopper link assembly handle pull shifted.
The motor should have come to a standstill
before the dirt hopper is removed. Risk of
injury through swirling waste and dust!
Ÿ
Hold the dirt hopper by the handle and pull it to the
rear and out of the machine.
Emptying the dirt hopper
Check the fill level of the dirt hopper regularly and empty
it regularly and as necessary.
Observe the applicable national laws and local
regulations when disposing of waste.
Inserting the dirt hopper
Ÿ
Insert the dirt hopper back in the machine from the
rear until they perceptibly engage in the hopper link
assembly
Ÿ
Pivot the handlebar towards the rear.
Changing the seals
Ÿ
Check the dirt hopper seals for wear on a weekly
basis and change the seals as necessary.
Ÿ
Remove the dirt hopper.
Ÿ
Pull the seals from the edges.
Ÿ
Press new seals on the edges.
Ÿ
Insert the dirt hopper.
Dust vacuum
Before starting any maintenance and repair work,
set the key switch to Position 0 to prevent starting
the machine inadvertently!
1. Front apron
2. Back apron
1
2
3
Hopper
handle
1
2