ROOTS RootsScrub RB 800 C, Руководство оператора, Страница: 12 / 23

12
RootsScrub RB 800 C
SQUEEGEE
Clean the squeegee before starting the work
cycle every time.
Do not stand on the squeegee.
Cleaning the squeegee
Check the squeegee everyday and clean as necessary.
To clean the squeegee, raise it, disconnect it from the
suction hose, loosen the knobs and remove the squeegee.
Wash the squeegee under clean running water.
PROCEDURE FOR SCRUBBING
MAX
5.0 mm
Water Level
Max. 10 °
Driving the machine
Do not park the machine on slopes or ramps.
Maximum inclination of 10°
is only allowed.
Maximum water wading of
5.0 mm is allowed.
The machine is powered by a powerful traction motor.
Starting-
To propel the machine press the accelerator pedal in downward
direction.
Stopping-
To stop or slow the machine release the accelerator pedal
(Pedal returns to its initial position). Press the brake pedal to
slow or stop the machine.
Proceed to the first driving trails on a clear training ground until
the driver is acquainted with the elements and their functions.
l
Before leaving the machine make sure to remove the
key.
l
Because of skidding hazard drive at reduced speed
on wet grounds and when turning.
l
Drive slowly on downhill, turning, wet grounds,
ramps and on uneven surfaces.
l
Do not drive the machine in flooded areas. Risk of
damaging the traction motor.
l
Never make sharp maneuvers while driving.
l
Do not adjust the seat while driving the machine.
Do not modify the machine to transport people or
goods.
Do not drive fast with the tanks full of water.
Start of cleaning
Ÿ
To fill clean water in the fresh water tank insert the
water hose into the fill port.
Ÿ
Add required amount of recommended cleaning agents
to the water.
Ÿ
Move the machine to the area to be cleaned.
Ÿ
Switch on key “A”.
Ÿ
Operate switch “M” to select the desired amount of
water flow.
Ÿ
Press “D” to lower the brush head - brush head lowers
and brushes rotate.
Ÿ
Press “E” to start suction turbine - suction turbine starts
and squeegee lowers.
Ÿ
Operate “C” to forward position.
Ÿ
Drive immediately or the brushes will leave traces on
the floor.
Ÿ
Commence cleaning operation of the area.
MALFUNCTION
OR
EMERGENCY
X
Do not tamper the traction motor
controller. Risk of damaging the motor.
In case of an emergency or malfunction - switch of key and
disconnect battery plug.
Squeegee
The parabolic squeegee is used to extract the dirty water
from the floor.
The sealing strips can be removed without the need for any
tools, as follows:
Ÿ
Remove the squeegee.
Ÿ
Remove the squeegee knobs.(1)
Ÿ
Release the Inner(3) and Outer clamps(4).
Ÿ
Pull the sealing strips (2).
Ÿ
Mount the new sealing strips through inverse sequence
of operation.
Replacement of Sealing Strips
1 3
4
2