ROOTS RootsScrub E 350, Инструкция по эксплуатации, Страница: 12 / 15

50°C max.
MACHINE OPERATION
Filling of water
Ÿ
Fill fresh water and detergent as described below
before start of operation.
Ÿ
Open tank lid and fold back.
Ÿ
Fill fresh water tank with water (50°C max.) And
detergent in relation to the dirt encountered and
according to the specifications by the manufacturer.
Ÿ
Filling quantity : 10 litres max.
Use detergents suitable for automatic
machines(low foaming) in order to preclude
D a m a g e s a t t h e s u c t i o n t u r b i n e . We
recommend Roots detergents for cleaning and care,
which are perfectly adopted to the machine. These
products fulfil the requirements of the Detergents
Act.
Operation
Ÿ
Use the button to take the support into working
position.
Ÿ
Turn switch “A” ON to make the brush rotate.
Ÿ
Turn switch “C” ON to open supply of fresh water with
or without detergent.
Ÿ
Turn switch “B” ON to start suction turbine running.
Turn all switches OFF after operation and remove the
brushes from the machine. Mount the brushes in inverse
order of dismounting before next operation. This
measure extends service life of the brushes.
Start operation of the machine by pushing
forward immediately after switching on. This
Measure extends service life of the brush
motor. When pushing in reverse direction lift the rear
squeegee with the squeegee governor. Make sure
that during the operation of the machine the mains
cable always lies behind the operator.
Turn the brush drive off before passing over
dormers of a height of 10mm and more.
Danger when passing over the mains cable with
rotating brushes. Start cleaning in the socket area
and clean by stripes. If the surface is not obstructed, start
at borders and forward counter-clockwise. Clean the
remaining surface by stripes and starting in the socket
area. Divide partly obstructed surfaces into areas in the
reach of the mains cable. Within shortest time, the
operator will know to avoid unnecessary hindrance
caused by the mains cable.
Ÿ
Turn machine off and set it to its park position.
Ÿ
Empty and rinse soiled water tank (see paragraph
”Dirty and Fresh Water Tanks”)
Ÿ
Clean sealing strips of the squeegee.
Ÿ
Check the sieve at the inlet opening of the fresh water
tank and clean if required in order to maintain suction
performance.
At the end of cleaning:
Do not clean the machine by means of a water
jet or high-pressure cleaning equipment to
avoid endangering your safety and the opera
ability of the machine.
Dirty and Fresh Water Tanks
The machine is equipped with a dirty and a fresh water
tank (lye tank). The filling amounts to 10 litres. Do not fill
beyond the maximum mark and do not exceed a water
temperature of 50°C
A suction hose delivers the dirty water into the dirty water
tank.
12
RootsScrub E 350
Do not take in larger amounts of secondary
water (water pools). To avoid settling of
residues empty and rinse the soiled and fresh
water tanks after work on principle.
Comply with the legal provisions for disposal
of dirty water. Check and clean the suction filter
in the tank lid for soiling in regular intervals.
Clean dirty and fresh water tanks
Ÿ
Slowly tilt the tank as represented to
drain water before cleaning the tank.
Empty Soiled water tank
Ÿ
Hold the tank as represented
Ÿ
Open the tank and drain water
Ÿ
Close cap
Cap
Fresh water tank
Soiled water tank
Filter
Float