ROOTS RootsScrub E 350, Инструкция по эксплуатации, Страница: 11 / 15

OPERATION SQUEEGEE
Ÿ
No tools are required for dismounting the sealing
strips. Proceed as follows
Ÿ
Dismount squeegee (refer to paragraph “Dismount
squeegee” ).
1
2
Ÿ Loosen screw and fix the brushes manually as represented
in direction 1.
Ÿ Open brush cover in direction 2.
Ÿ Remove brushes.
Ÿ Clean brush compartment.
Ÿ Insert brushes, close brush cover and secure with screw.
Ÿ Set machine in upright position.
Ÿ Use adjustment screw to set the operating handle into
working position.
Ÿ Set front support roller into working position.
Ÿ Re-insert fresh and soiled water tanks.
Squeegee
The machine has been equipped with a squeegee of 450
mm working width. The squeegees can be lifted-out
alternately.
Check the squeegee for collected foreign
particles and for proper condition before start
of operation.
1
2
3
1. Squeegee
2. Squeegee screw
3. Squeegee holder
Mount Squeegee (Initial Fitting)
Ÿ
Lift squeegee and hold it to the squeegee holders (3).
Ÿ
Mount squeegee (1) to the squeegee holder by
means of screws (2) as represented.
Ÿ
Check the smooth running of the bottom sleeve at the
squeegee holders for perfect hinging.
Ÿ
Lift brush head of the machine in order to access the
squeegee screws.
Ÿ
Remove both screws (2) as represented.
Ÿ
Pull squeegee to the bottom to remove it from the
machine.
Dismount Squeegee
Change Sealing Strips
11
RootsScrub E 350
Ÿ
Unscrew knurled screw (1).
Ÿ
Remove support strip.
Ÿ
Proceed to mounting of new sealing strip in reverse.
Ÿ
Tighten the knurled screws (by hand) and from the
center towards the outsides (slotted sealing strips point
to the front, plain ones to the back).
1
2
3
1. Knurled screw
2. Support strip
3. Sealing strip
The rear sealing strip can be turned round if
worn at the front edge.
Clean nozzle
The nozzle clogs after some hours of operation. It thus
required to clean the nozzle at daily intervals before start
of operation.
Ÿ
D i s m o u n t b r u s h e s f r o m t h e m a c h i n e ( s e e
“Dismount/Mount Brushes”).
Ÿ
Lift machine and lay down on its back as represented.
Ÿ
Turn the nozzle to the left.
Proceed as follows for cleaning the nozzle:
1. Remove nozzle
NOZZLE
Tighten
Loosen
Ÿ
Clean nozzle by compressed air or water.
2. Clean nozzle
3. Mount nozzle
Ÿ
After cleaning, insert nozzle by screwing clockwise
make sure that the nozzle slot is as the mounting
direction of the brushes upright machine.
Nozzle Slot