ROOTS BT4545, Руководство пользователя, Страница: 13 / 24

13
RootsScrub BT Series
OPERATION - BRUSH
Installation of brush
Disc Type
The brush must snap in immediately. A rattling
noise indicates that the brush head is not
correctly centered. Turn off switch ”A”, correct
the position of brush head and turn on switch “B”
for locking. Now the brush is locked. Repeat
locking operation.
Brush Lifting
Ÿ
Pedal is used to lift and lower the brush.
Ÿ
For lowering, first press the pedal a little to outside
(unlock) and then allow it to move slowly upwards.
Ÿ
For lifting, press the pedal slowly downwards and
make it lock.
Brushes / Pads
The machine must be equipped with brushes from the
accessories kit, as required by the degree of dirtiness
and kind of ground.
Ÿ
The tank should be empty.
Ÿ
Lift the squeegee.
Ÿ
Place the brush in front of the machine.
Ÿ
Raise the brush head.
Ÿ
Move the brush to center of the brush head.
Ÿ
Lower the brush head so that the catch is centered in
the brush.
Ÿ
Turn on switch “B” for a short time in order to allow
locking.
When lowering the machine pay attention to
prevent the pedal for lifting of the brush head
from being pressed down.
Removal of brush
Ÿ
Empty the tanks.
Ÿ
Lift the squeegee and the brush
head.
Ÿ
P r e s s s w i t c h “ D 1 & D 2 ”
simultaneously for unlocking of
brush.
Ÿ
Press the rear end of the machine
downwards.
Ÿ
Pull the machine towards the rear.
Ÿ
Brush is now lying in front of the
machine.
Pedal to
raise/lower
the brush
Installation of brush
Ÿ
Remove screw of the brush cover.
Ÿ
Fasten supplied brushes at the drive rollers at the
inside of the opposite cover.
Ÿ
Close brush cover such that the guiding rollers and
the brushes catch safely.
When mounting, check the safe catching of
rollers and brushes.
Before cleaning or maintaining the machine as
well as before replacing parts of it, turn the
machine off.
Cylindrical Type
Debris Cleaning
Ÿ
Tilt the debris tray towards machine side and pull it
out.
Ÿ
Now empty the tray by inverting it and shaking.
Ÿ
Clean the tray and place it back for further cleaning
Removal of brush
Ÿ
Raise the brush head and set to its parking position.
Remove the screw at the idler end, open the cover
and pull the brushes towards the user.
Ÿ
Close the cover and retighten the screw.
When inserting the brushes for the next
operation, make sure to change position of
the brush such that one-sided brush wearing
is preluded.