18
These units are equipped with a local switch used as
general terminal board.
The switch can be padlocked.
The electric connection of range RT is done in a single point on the level of the principal circuit breaker.
2207
210
184
59
263
Ø 23
2106
DÉTAIL C
C
A circuit breaker or fuse holder ( not supplied ) must be installed on the
main power supply of the unit in accordance with the circuit diagram; for
the raitings, refer to the electrical specifications.
Electrical power supply cable should be
inserted by the base or on the side of the
unit.
In this case, cable holes need to be drilled
in the panel located under the proximity
switch in relation to the thickness of the
power cables. This panel is equipped with
a grommet intended for
the interconnecting cables
between the different units
on a same installation.
Maximum electric power
supply cable section:
240mm²
Copper wire cable only
Содержание 100
