RooDog Polka dot, Руководство пользователя

Страница: 8 / 20

8 | www. roodog .co.uk
Bike Assembly:
Tools Required: 4, 5 and 6mm Allen keys, 10 and 15mm spanners
›
Remove all packaging carefully: and select a good area to
assemble the bike. Preferably on a non abrasive surface so
you don’t damage the bike.
›
Easier with two people: Have someone hold the bike
upright for you. Then remove the bolt on the arch of the front
suspension fork using the 10mm spanner and the 5 mm Allen
key.
›
Front Light and Front Mudguard: To fit the front light and
mudguard align the holes with the top of the front suspension
hole. Insert the Allen key bolt and loosely tighten (don’t fully
tighten yet). Take the bolts from the side of the forks out, place
the support arms over the holes and replace the bolts to
secure the mudguard in place. Once complete, tighten bolts
fully.
›
Handle bars: Pick up handle bar and stem and remove the
plastic cover from the bottom. Slide the stem down the front
suspension shaft. Locate the 6mm Allen key hole at the top
of the stem, adjust the height to suit the rider then align the
bars straight and tighten the Allen key bolt.
›
Front wheel: Place bike in a bike maintenance stand or turn
up side down so the bike is standing on the handlebars and
saddle but again try to do this on a non abrasive surface
to avoid damage. (remove battery first in order to lighten
and make it easier to maneuver the bike) Once in position
take the front wheel and the quick release skewer/axle bolt.
Undo the plastic end cap and take off one spring (leaving
one spring on). Slide the bolt through the Centre of the front
wheel until it comes out the other side, then place the spring
back on first (small end first) followed by the plastic end cap
and loosely tighten. Pick the wheel up and slide into the
slots provided on the front fork and push downwards until
it stops. Once aligned you can tighten up the skewer bolt.
(lever should point upward when fitted correctly)
›
Disc brake: If not already correct adjust brake by releasing
brake cable with 5mm Allen key then adjust accordingly and
re-tighten. Spin the wheel to make sure it spin freely. You
can make minor adjustments by turning the plastic screw
located on the brake cable near the brake caliper and with a
5mm Allen key on the opposite side.
›
Pedals: Locate pedals, separate left and right pedals
indicated by L / R print on threaded end of the pedal. Screw
in each pedal in to the crank arms with your fingers ensuring
not to cross thread them. Once located correctly, tighten
with 15mm spanner.
Note: Your wheel should fully stop once the brake lever
is depressed halfway. If it does not stop, re-adjust them
accordingly.