USER MANUAL
13
your nylon line cutting head only with nylon trimmer line of the proper
diameter.
WARNING!
Use extreme caution when operating over bare spots and gravel,
because the line can throw small rock particles at high speeds. Debris
shields on the unit cannot stop objects which bounce or ricochet off hard
surfaces.
For nearly all cutting, it is good to tilt the line head so that contact is
made on the part of the line circle where the line is moving AWAY from
you and the debris shield. (See appropriate) This results in the debris
being thrown AWAY from you.
TRIMMING
Tilt the head slowly to direct debris away from you. If cutting up to a
barrier such as fence, wall or tree, Approach from an angle where any
debris ricocheting off the barrier will fly away from you, Move the line
head slowly until the grass is cut right up the barrier, but do not jam
(overfeed) the line into the barrier.
If trimming up to a wire mesh or chain linked fence be careful to feed
only up to wire. If you go too far the line will snap off around the wire.
Trimming can be done to cut through weed stems one at a time. Place
the trimmer line head near the bottom of the weed-never high up which
could cause the weed to chatter and catch the line. Rather than cut the
weed right through, just use the very end of the line to wear through the
stem slowly.
Debris
Cut ON This Side
