10
DEMOLITION HAMMER
ASSEMBLY
.
CARRYING HANDLE
The carrying handle can be turned to any position. Loosen the
hand wheel, turn the carrying handle around the machine axis
to the desired position and tighten the inner hex bolt again.
.
INSTALL BIT
WARNING!
Before any work on the machine itself, pull the mains plug out
of socket.
- Clean the bit shank and apply a light coat of grease.
- Pull out the limit bolt and turn it 180° in anticlockwise direction.
- Allow the limit bolt to latch again.
- Insert the bit into the bit holder to the stop. The groove of the
bit shank must face upward.
- Pull out the limit bolt and turn it 180° in clockwise direction.
- Allow the limit bolt to latch again.
- Check the latching by pulling the bit.
