Ronde & Schwarz NRX, Начало работы

Страница: 14 / 27

Preparing for Use
R&S
®
NRX
14 Getting Started 1424.7070.02 ─ 05
The R&S NRX initiates its startup procedure. It boots the operating system
and starts the instrument firmware.
If the previous session ended regularly, the R&S NRX uses the settings from
the last session.
3. If you want to return to a defined initial state, perform a preset.
To switch off the R&S NRX
1. Press the [on/standby] key.
The R&S NRX saves its current settings for reuse in the next session and
changes into the standby state.
2. To power down the R&S NRX completely, set the AC power switch to position
[0] (Off).
Further information:
●
Chapter 5.1.6, "On/Standby Key" , on page 22
4.8 Connecting Power Sensors
The R&S NRX supports a wide range of R&S power sensors. See the data sheet
for detailed information.
Depending on the power sensor, you have different choices for connecting it.
4.8.1 Sensor Connectors A to D
See Chapter 5.1.1, "Sensor Connector A and B" , on page 17 and Chap-
ter 5.2.7, "Sensor Connectors C and D" , on page 25.
Suitable for:
●
USB and LAN power sensors
●
R&S NRQ6
●
R&S NRP
‑
Zxx power sensors
Connecting Power Sensors