13.
Installation
1.
Turn the Bear upside down. Using a cross-head screw driver open the battery
compartment.
2.
Insert three AA batteries, observing the polarity indicated.
3.
Close the battery compartment and tighten the screw to secure in place.
4.
Connect the Bear to a switch (not included) via the jack socket at the
end of the cable attached. The socket is 3.5mm.
5.
Make sure the ON/OFF switch is set to ON. Activate the Bear by activating the
switch you have just connected. The operation is latched – activate your switch to
make it play and activate the switch again to make the Bear stop. The play sequence
is approximately 2 minutes and will stop automatically when complete. If the Bear is
stopped, it will start again at the beginning of the sequence when your switch is
activated again.
6.
The Teeth Brushing Bear can also be operated by pressing the paw with the spiral
pattern.
7.
The Bear does not have a volume switch.