Power supply and the adaptors for different countries:
13.
Installation
1.
Place on a flat, stable floor that is capable of holding the weight of this product.
2.
Plug the power lead into A.
3.
Fill with clean water carefully until the required level is achieved. This should be
approximately 5cm (2 inches) from the top of the tube. The water level will rise when
switched on. Make sure that the jug or bucket you are using to fill the tube is also clean.
Put bubble tube cap (lid) on top of the bubble tube.
4.
Once the power lead is plugged in at the wall, the green ON indicator light B will be
illuminated.
5.
Adjust the intensity of the bubbles using the INTENSITY potentiometer knob C, located
to the left of the base controls. There are limits how far this can be turned. Please note
that as the intensity of the bubbles increases (the further clockwise it is turned), so will
the background noise from the integral pump.
C
B
A