14. Care and Maintenance
The fixture should only be cleaned with a dry cloth, ensuring the fans are
free from dust.
Use a soft tissue or lens cloth with a little methylated spirit or pure alcohol.
After six months (or 1000hrs) usage the optical system might need cleaning. Switch off
the projector, disconnect from the mains.
Remove the four cover plate screws and remove the cover plate. There is no need to
remove the mounting bracket.
Use a soft tissue or lens cloth with a little methylated spirit or pure alcohol to clean the lenses.
Do not touch the LED module, it may fail if touched.
Carefully re-fit the cover and replace all four screws.
15. Troubleshooting
Problem: The Clip On Prism (or other accessory) will not fit on the front lens of the projector
• Check that the ‘click-clack’ has not been removed. This is a cylindrical piece that sits inside
the lens (shown below). Check that this is not still attached to the accessory that has
previously been removed from the projector. Reattach this part to fit an accessory onto the
front lens in order to attach an accessory.
In the unlikely event of product failure, please contact us.
Further copies of these instructions can be downloaded at www.rompa.com
We hope you find our instructions invaluable. If you have any suggestions for improving
them further your comments will be greatly received – please contact us at
100LED (Mini Projector) 21206, May 2016
Copyright ROMPA® Ltd