Step 6 - Sealing
1. Lift the Wall to Dam Joint and place a bead of silicon to the base, add a bead of silicon on the inside of the Wall to Dam
Joint at the side that goes over the rails and refit.
2. Place a bead of silicon around the top of the Wall to Dam Joint and up the sides.
3.
Place a bead of silicon around the top of the Dam to Profile Joint and up the sides.
4. Seal the base of the enclosure horizontally on the outside only
where it meets the tray/wetroom floor.
5.
Seal the Wall Profile all the way up from the tray/wetroom floor on the
inside and outside.
•
Do not seal along the base on the inside, failure to comply may result in leakage.
• Please allow 24 hours for the sealant to fully cure before using the enclosure.
• IMPORTANT: Failure to follow the above may result in serious water damage and will not be covered under the
terms of the guarantee.
Add Silicon
to base
Add Silicon
to inside
①
②
③ ⑤
