Step 7 – Fitting the Screw Cover Trims & Sealing the Door
1. Press fit the screw infill trims into the vertical grooves of the wall profiles.
•
•
Cut the cover trims level with the top of the wall profile using a stanley knife or an alternative blade, please take care
when cutting.
Tip:
You might find it easier to slide the cover trims down into the groove.
2. Fit the top caps to the top of the door as shown.
3. Using a good quality sealant seal both sides of the wall profile inside and outside vertically where it meets the tiled wall.
4. Seal the base of the corner panel to the wetroom floor/tray from the outside only
•
•
Very important: Failure to follow the procedure in lines 3 – 4 may result in serious water damage and will not be
covered under the terms of the guarantee.
Do not seal along the base of the product from the inside, failure to comply may result in the product
leaking.
Please allow 24 hours for the bathroom sealant to fully cure prior to using the enclosure.
5. Stick on the branding badge.
➀
➁
➂
➃
ET Sliding Door:CSP 4/5/10 11:33 Page 8
