Step 3 – Wall Profile Positioning and Drilling (Alcove) 2nd Wall Profile
1. Remove the handle from the packaging, using the supplied 2.5mm Allen key (supplied) remove screws and split the handle,
dismantle and re-assemble onto the door as shown.
Important: If fitting the product in conjunction with an in-line or side panel please now refer to your panel instructions
.
This wall profile will be fitted on the opening side of the door
1. Position the wall profile approx. 15mm in from the front of the tray.
2. Using a pencil mark the locations for the drill holes through the lip of the wall profile using the holes as a guide.
3. Drill the holes using 6mm masonry drill bit (not supplied). Push the wall plugs (supplied).
Important: The 2nd Wall profile will be screw fixed to the wall at a later stage in the installation.
Step 4 – Fixing the Handle
➀
➁
➂
ET Sliding Door:CSP 4/5/10 11:33 Page 5