Step 3 - Fix the Curved Panel (and end panel if applicable)
1. Remove the black transit caps from all the glass panels.
2. Screw the location pin into the curved profile that is assembled onto the large curved piece of glass.
3. Offer the Curved panel into location in the wall profile and position the location pin into the hole in the tray.
4. Drill through the pre-drilled holes of the wall profile using a 3mm drill bit.
5. Fix the panel into wall profile using the supplied 16mm pan head screws.
6. Offer the Side panel into location on the tray and in the wall profile; make sure the glass is running parallel to the
side of the tray, and is sitting horizontally along the tray. (Fix side panel repeating points 4 and 5).
•
(If you are fitting the enclosure straight to floor see the guidance page at the back of these instructions).
•
(You may need help to perform the installation steps, particularly to lift and hold the glass panels in location).
(Pease ensure the transport bands are removed with care from the glass panels in this and the following steps.)
FC:CQB
4/5/10
12:13 Page 4
