Roller Pro RP-HOPPER 4, Руководство пользователя

Страница: 7 / 12

1 Insert the head tube and fold out the kick
stand.
2 Install the handlebar on the head tube.
3 Use the supplied hex wrench to fasten the
screws on both sides.
4 After installation you can switch the scooter on.
CHARGING
1. Ensure the scooter is turned off before proceeding to charge the battery.
2. Locate the charging port on the bottom part of the scooter.
3. Use the supplied charger to connect it to the charging port and to the wall outlet.
4. While the scooter is charging, the adaptor indicator light will turn red.
5. Once the scooter is fully charged, the adaptor indicator light will turn green. Disconnect the AC
charger from the port and the wall outlet.
6
Remove the rubber
from the connector
Insert the
charging plug
After charging, replace
the rubber cap
If charging for the first time, charge the scooter for at least 4 hours before using it. Make
sure the E-scooter is turned off.
Do not use any other charger than the one which is supplied with your Hopper E-scooter.
If you use any other charger, it will cause failure and the warranty will be void.