Electronic thermostat
Green pilot light
On/off switch (refrigerated part)
On/off light
On/off switch (warming part)
Thermostat
Led light
Mirror
5. FUNCTIONING / MANIPULATION
a) Installation / assembly
:
- Unpack carefully the appliance from its packaging
- Place the equipment on a stable and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible mate-
rials even if it is very well isolated.
- A distance of 10 cm from the partition or the wall is considered enough.
- Remove the protective film from the appliance.
- Position the accessories (see 11. Installation guide)
b) First starting
:
For the warming part (right container)
Fill the container with water (about 5 cm above the heating elements) before switching
on the salad’bar.
Do not let it run without water : it could damage the heating elements and irremediably
bend the container.
To avoid quick evaporation, cover the whole tank with containers or lids.
First cleaning
Clean the device before the first use. (See 6 Cleaning)
Connection of the device
- Check that the tension and the frequency of the electricity network suit to the val-
ues indicated on the descriptive plate.
- Check that neither the cord nor the plug are damaged
- Make sure that every control knob is positioned on 0.
- Unwind completely the electric power cable and connect it in a normalised plug
with the earth.
- The device is connected.
NB: in case of connection of the device in a plug without earth protection or directly
on the electricity network, confide its connection to a qualified person .
4
6
4
2
1
5
3
7
8
Your salad’bar is ready. You can place it and plug in with normalized 220-240 V ~
according to the instructions manual
.
11
C. Mounting of the plexiglas
Remove the protective film.
Place the plexiglas under the stainless
steel roof (Picture L) and fix the screws
D (Picture F on page 2).
6. Connection
Connect every wire. ( Picture M)
7. Fix the protection for wires
Fix the stainless steel protection for wi-
res with the screws B (Picture F on
page 2 + Picture N)
8. Final fixation of the mirror
Insert both screws C on the back top of
the uprights (Picture F on page 2 + Pic-
ture O)
Photo N
Photo M
Photo O
Picture L
