7
Power LED
Switch Mode Dial to
“Full Auto” mode
Getting the Camera Ready
Installing Memory SD/MMC Card and Battery
1
Open the battery/memory card cover and slide the
memory SD/MMC card (optional) and two new AA
Ni-MH batteries or one CRV3 Lithium battery into
compartments.
2
Close cover securely until it clicks shut.
3
Battery level is shown in 3 stages, Full Battery, Low
Battery, and Insufficient Battery. Only Low Battery and
Insufficient Battery are indicated on LCD screen.
NOTE
Be sure the correct orientations of the batteries and
SD/MMC card.
Remove batteries if camera is not used.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.
Switching the Camera ON/OFF
1
To switch ON, turn Mode Dial from OFF to the desired
shooting mode
(
)
. Use “Full Auto”
(
)
mode if it’s your first time to use. Green power LED
lights up when power is ON.
2
To switch OFF, simply return the Mode Dial back to “Off”
position and the Green Power LED lights OFF.
Viewing the Total/Remaining Shots Available
1
Turn ON the camera.
2
The total/remaining shots number of internal memory is
displayed. If a memory SD/MMC card is installed, the
LCD will display the total/remaining shots number of the
SD/MMC card.
Note
: The displayed memory capacity will vary
according to the set of image resolution.
Battery Low Alert
When the battery becomes low, a low battery icon will
display and the red Power LED will blink. Replace batteries
when power is low.
Image Resolution
AF Zone
Total/remaining shots
Low Battery
Alert
Batteries
SD Card
–
+
OFF
OFF
O
FF
SCENE
SCENE
SC
EN
E
