Operation manual / Spare parts list
Single disc machines
10
4
Assembly
The machine is delivered ready to use.
The assembly of the sanding or special disc occurs only at the application place.
5
Transport
In many cases it is inevitable to transport resp. carry the machine to the point of utilisation.
Due to the low weight and the manual measurements no instruction references are required for this.
Caution, Fragile!
Do not throw the machine and do not transport it without securing it onto the load area.
6
Operation
6.1
Assembly of the disc (accessory)
1. Switch off the machine and disconnect the connection cable from the mains. Turn over the
machine backward on the floor with upright handle. For this push on the back wheels.
2. Lock the discs in loose flange of the machine (Bayonet connector).
Set the machine in horizontal position again.
3. Attention: Do not set the machine on accessory discs and switch on the machine to lock in –
machine and discs can be damaged - no guarantee!
To loose the disc – turn clockwise
6.2
Preparation of the machine
Adjustment of the handle
For a light and exact use of the machine the right height setting of the handle is important.
To adjust the handle, pull right lever and adjust the handle in the right position, body height of the
operator (basin-height).
