ROLEC OCPP0010, Руководство по установке и эксплуатации

Страница: 10 / 24

Installation
AutoCharge:EV OpenCharge EVACOCM-01-V02-R3 Installation and Operation Manual
Page 9 of 21 December 2021
Installation
IMPORTANT: Installers and End Users must read and understand the content
of this manual before installation and/or use of the product.
Installation must only be performed by someone who is properly qualified and
competent to do so in accordance with the current legislation in force in the
geographical location of the installation.
x
Advice provided in this manual does NOT override any legislation.
x Rolec Services Ltd cannot accept any responsibility for improper installation or any
problems arising from improper installation.
NOTE: Damage to the equipment, connected systems or to property caused by
improper installation are the responsibility of the installer.
Before Installation
1. Establish a suitable site location for the charger that is both secure and
environmentally safe.
2. Make sure the location meets current legislation (if applicable).
3. Make sure that the charger and any accessories have not been damaged in
transit.
NOTE : Items damaged in transit must first be reported to the courier and then to the
supplier.
Where possible, photographic evidence of package and/or unit damage should be
supplied.
4. Make sure the charger model is correct and matches the order.
NOTE : Incorrect or damaged units must NOT be installed. Contact your supplier to
discuss rectification.
5. AutoCharge:EV OpenCharge units using GPRS to communicate with the cloud-
based back office require a suitable GPRS signal of 14 CSQ or better.
NOTE : Units using GPRS contain a roaming SIM card which will always connect to the
strongest signal available. It is assumed that a suitable GPRS signal has already been
verified by the end user/installer prior to installation.
x
Rolec cannot be held responsible or accountable in the event a GPRS unit is
installed in a location without adequate network signal.
Base Installation – If Supplied:
1. Prepare the ground and set the ground mounting base in the desired location.
x Make sure ALL cables are fed upward through the middle of the base.
2. Concrete the base into place and allow time for it to set.
x The lip of the base should be 2 – 3 mm above the surface.